Hi,
I am struggling to see why my SDP is not being set correctly on the
INVITE to my supplier with Proxy-Authentication when I use uac_auth().
The initial INVITE to my supplier has correct SDP set by
rtpengine_manage. Then supplier replies with a 407. My failure route
correctly handles the Auth, and also calls NATMANAGE again... but this
time the SDP is unchanged and the private IP and original media
information from the original device is relayed to my supplier.
kamailio.cfg isbased on the default config. Running kamailio 5.4.6 and
using example from uac module for uac_auth.
My failure route calls NATMANAGE. Is there anything special about
uac_auth? Do I need some extra magic to apply the message body changes
after I have run rtpengine_manage().
====================
Extract of kamailio.cfg
failure_route[TRUNKAUTH] {
if (t_is_canceled()) {
exit;
}
route(NATMANAGE);
xlog("L_INFO","In failure route, just finshed NATMANAGE and now body is $mb");
if(t_check_status("401|407")) {
# $avp(auser) = "test";
# $avp(apass) = "test";
# $avp(apass) = "36d0a02793542b4961e8348347236dbf";
if (uac_auth()) {
t_relay();
}
exit;
}
}
Hello,
I am trying to use Kamailio in our application which would be deployed in certain environment in addition to a cloud infrastructure. As I understand it, parts of the Kamailio code are covered under the BSD license - are you able to share what those are? I am trying to determine if Kamailio can be used in a customer environment or should it be strictly restricted to cloud environments due to the GPL v2 licenses
Thanks,Steve
