[SR-Users] Re: Rtpengine: no audio after kernelization.

Hi Everyone, I’m having the same issue but believe it’s related to my network topology. I have multiple carrier-facing NIC’s and an internal NIC on each media proxy. Is this configuration supported? I have the named ‘public / providerA / providerB’ rtpengine interfaces setup and working correctly – media flows as expected when running rtpengine without the kernel module. When kernel module is in use I get a few seconds of 2-way audio initially before it drops out in one direction usually. [root(a)per01-mtp01.dev.xyz blah]# cat /proc/rtpengine/0/list local inet4 203.x.x.x:40000 stats: 350880 bytes, 2040 packets, 0 errors RTP payload type 0: 0 bytes, 0 packets RTP payload type 8: 350880 bytes, 2040 packets SSRC in: 65aa31af output #0 src inet4 10.y.y.y:40000 dst inet4 203.x.x.x:39302 SSRC out: I was also looking to find some config to make this working using firewalld rules, fishing through the Sipwise repos I stumbled across some firewalld rules as part of their automated builds but didn’t have any luck with them If somebody had some rules I could try would be much appreciated! Cheers, Tim From: sr-users &lt;sr-users-bounces(a)lists.kamailio.org&gt; On Behalf Of Michel Pelletier Sent: Tuesday, 13 December 2022 10:04 PM To: Kamailio (SER) - Users Mailing List &lt;sr-users(a)lists.kamailio.org&gt; Subject: Re: [SR-Users] Rtpengine: no audio after kernelization. Hello, Thank you for your reply. I checked the versions and they look good. xt_RTPENGINE is 11.1.1.3 and the daemon is 11.1.1.3-1~bpo11+1. Looking at /proc/rtpengine/0/list I see the packet and byte counters incrementing normally with 0 errors. In wireshark, capturing on any, I see the stream coming in on the private network interface but nothing going out through the public network interface. Everything is good until 5 seconds into the call when the kernelization happens. Michel Pelletier On Mon, Dec 12, 2022 at 2:19 PM Richard Fuchs <rfuchs@sipwise.com<mailto:rfuchs@sipwise.com>> wrote: On 12/12/2022 14.53, [EXT] Michel Pelletier wrote: Inspect /proc/rtpengine/0/list while a call is running, in particular paying attention to the packet and byte counters. Also double check that the version of the rtpengine daemon matches the version of the kernel module (and that the module has been reloaded if there have been any upgrades - `dmesg` or `kern.log` are good places to check that). Cheers __________________________________________________________ Kamailio - Users Mailing List - Non Commercial Discussions sr-users@lists.kamailio.org<mailto:sr-users@lists.kamailio.org> Important: keep the mailing list in the recipients, do not reply only to the sender! Edit mailing list options or unsubscribe: https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users