At 03:23 PM 8/20/2003, Hassan CHOUMAR wrote: The username is subject to a RegExp check, which is specified in functions.php, $reg_validate_username="^((8[0-9]*)|([a-zA-Z][a-zA-Z0-9.]*))$"; As you see, usernames beginning with 9 are not accepted. Well, I guess you better ask Cisco about IOS configuration. I suggest you to use rewritehostport to change URI to gateway's host address. The gateway would deny the request otherwise. Modulo correctly: rewritehostport("192.168.0.2"); t_relay(); -jiri

Hello all, I installed serweb, it works well, but I have a problem at the level of the> application: Another question, if I want to try to make communications between a softphone SIP and an analogical telephone through a cisco router, it is enough to go the commands this below into the cisco router, and the others into the server SER: For that of an entering call has fault Gateway is indeed but that of the call taking out that is call of a softphone towards an analogical device I did not manage to realize it. In the router: Dial-peer voice 999 voip Destination-pattern 555999. ** Associate the number arranges 555-9990 to 9999 with our SIP server Session protocol sipv2 ** Set this dial-peer to uses(wears out) SIP instead of Cisco protocols Session target sip-server ** Send the call to our SIP server. See SIP-UA below Codec g711ulaw ** Set the default codec to 711-Ulaw (common codec between customers) ! Sip-ua Sip-server ipv4:192.168.0.1 In the file ser.cfg : if (uri=~"^sip:9[0-9]*@mydomain.com") { ## This assumes that the caller is log("Forwarding to PSTN\n"); ## registered in our realm t_relay_to( "192.168.0.2", "5060"); ## Our Cisco router break; }; thanks you for advance hassan ------------------------------------------------- This mail sent through IMP: http://horde.org/imp/