15 Sep
2003
15 Sep
'03
4:38 p.m.
Hello all,
I installed serweb, it works well, but I have a problem at the level of the>
application:
Another question, if I want to try to make communications between a
softphone
SIP and an analogical telephone through a cisco router, it is enough to go
the commands this below into the cisco router, and the others into the
server
SER:
For that of an entering call has fault Gateway is indeed but that of the call
taking out that is call of a softphone towards an analogical device I did not
manage to realize it.
In the router:
Dial-peer voice 999 voip
Destination-pattern 555999. ** Associate the number arranges 555-9990 to 9999
with our SIP server
Session protocol sipv2 ** Set this dial-peer to uses(wears out) SIP instead
of
Cisco protocols
Session target sip-server ** Send the call to our SIP server. See SIP-UA
below
Codec g711ulaw ** Set the default codec to 711-Ulaw (common codec between
customers)
!
Sip-ua
Sip-server ipv4:192.168.0.1
In the file ser.cfg :
if (uri=~"^sip:9[0-9]*@mydomain.com") { ## This assumes that the caller is
log("Forwarding to PSTN\n"); ## registered in our realm
t_relay_to( "192.168.0.2", "5060"); ## Our Cisco router
break;
};
thanks you for advance
hassan
-------------------------------------------------
This mail sent through IMP: http://horde.org/imp/