30 Jun
2011
30 Jun
'11
3:20 p.m.
In the later versions, you could use the following parameter:
3.23. ds_probing_mode (int)
Controls what gateways are tested to see if they are reachable. If set
to 0, only the gateways with state PROBING are tested, if set to 1,
all gateways are tested. If set to 1 and the response is 408
(timeout), an active gateway is set to PROBING state.
Default value is “0”.
Example 1.24. Set the “ds_probing_mode” parameter
...
modparam("dispatcher", "ds_probing_mode", 1)
...
In this case, the Dispatcher module would send a OPTIONS-request to
all the gateways and if it replies with a "200 OK", enable them
again....
Carsten
2011/6/29 vaad.fabi(a)gmail.com <vaad.fabi(a)gmail.com>om>:
Hi all,
Is it possible to autochange gateway's state from pending to active after gw
get up ?
http://www.kamailio.org/docs/modules/1.4.x/dispatcher.html says only about
ping caused autochange state from active to pending, but nothing about
change gw's state back.
--
Vadim F.
_______________________________________________
SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list
sr-users(a)lists.sip-router.org
http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users
--
Carsten Bock
http://www.ng-voice.com
mailto:carsten@ng-voice.com
Schomburgstr. 80
22767 Hamburg
Germany
Mobile +49 179 2021244
Office +49 40 34927219
Fax +49 40 34927220