Re: [SR-Users] gmake: *** [cfg.tab.h] Broken Pipe while make kamailio on solaris 10

Date: Wed, 2 Jun 2010 16:54:26 +0200 From: andrei(a)iptel.org To: kevin.jzh(a)hotmail.com CC: sr-users(a)lists.sip-router.org Subject: Re: [SR-Users] gmake: *** [cfg.tab.h] Broken Pipe while make kamailio on solaris 10 On Jun 02, 2010 at 08:32, JinKevin <kevin.jzh(a)hotmail.com> wrote: [...] Now I remembered :-) The problem on sparcv9 is that you can build either sparc32 or sparc64 code. The make system tries to use the configured compiler and use its default architecture, in this case sparc32. This changed from older ser or kamailio version, where IIRC 64 bits was always used on sparcv9 (the isainfo arch was used). The change was needed for better cross-compiler support, snow leopard (boots 32 bits kernel, but gcc is configured to produce 64 bit binaries). So if you have all the needed 64 bits libs installed, you should compile for sparc64. Either make config CC_EXTRA_OPTS=-m64 or make config ARCH=sparc64 should do it (don't forget to re-run it after any make proper). [...] I couldn't reproduce the yacc/bison problem. For me it compiles flawlessly on an old sparcv9 (solaris 9, bison 1.875d). Could you try running: yacc -d -b cfg cfg.y by hand and see what happens? (any error? cfg.tab.h and cfg.tab.c created?)