OK. A little trial and error and I think I found the problem. I
changed the failure_route to include the command lookup("location").
I'm not clear why this makes a difference but it does. The new
failure route is:
# Iterate through extension list for subscribers with call hunting
enabled
failure_route[6] {
if (avp_pushto("$ruri/username", "s:huntlist"))
{
lookup("location");
append_branch();
avp_delete("s:huntlist");
t_on_failure("6");
t_relay();
};
}
Thanks,Steve
Steve Blair wrote:
Greger:
This technique almost works. Two things are happening which I cannot
fully explain. Perhaps you can help. First, does the avp_db_load
load the values in a specific, predictable order? Second, I cannot
seem to hunt to a third number. I believe this is because the call
to the second number causes SER to exit failure_route[6] effectively
stopping the hunt. Do you or anyone else on this list have any
thoughts on why I can only hunt trough the second number?
Thanks,Steve
Steve Blair wrote:
>
> Greger:
>
> So something like the following:
>
> # hunting (serial forking)
> if (avp_db_load("$ruri/username", "s:allow_hunt")) {
> if (avp_check("s:allow_hunt", "eq/y/i")) {
> avp_delete("s:allow_hunt");
> avp_db_load("$ruri/username", "s:huntlist/sam");
> t_on_failure("6");
> t_relay();
> break;
> };
> };
>
> # Iterate through extension list for subscribers with call hunting
> enabled
> failure_route[6] {
> if (avp_pushto("$ruri/username", "s:huntlist"))
> {
> append_branch();
> avp_delete("s:huntlist");
> t_on_failure("6");
> t_relay();
> };
> }