25 Apr
2007
25 Apr
'07
5:37 a.m.
Hello Juha,
Well, in my case the IP belongs to an asterisk server which then sends
the call to 5 PSTN gateways. I use this trick with the 5 different
prefixes to make asterisk choose between the 5 PSTN gateways. It works
fine in db mode but not in cache mode. Shouldn't lcr behave the same in
both modes?
I tried working around this by puting the 5 entries into 5 different gw
groups (this sounds like a bigger hack to me than what I am currently
doing). Still, in cache mode the same entry is always picked.
Regards,
George
-----Original Message-----
From: Juha Heinanen [mailto:jh@tutpro.com]
Sent: Wednesday, April 25, 2007 11:43 AM
To: Papadopoulos Georgios
Cc: users(a)openser.org
Subject: [Users] LCR in cache mode
Papadopoulos Georgios writes:
Disclaimer
The information in this e-mail and any attachments is confidential. It is intended solely
for the attention and use of the named addressee(s). If you are not the intended
recipient, or person responsible for delivering this information to the intended
recipient, please notify the sender immediately. Unless you are the intended recipient or
his/her representative you are not authorized to, and must not, read, copy, distribute,
use or retain this message or any part of it. E-mail transmission cannot be guaranteed to
be secure or error-free as information could be intercepted, corrupted, lost, destroyed,
arrive late or incomplete, or contain viruses.
My gw table contains a gateway group with 5
entries which
have the same > IP but different prefixes. If I use lcr
module in cache mode > (db_mode=1), the same entry is always
picked. If I use lcr in db mode, > then it works as expected
and it picks randomly one of the five entries.
Is this a known issue? My Openser version is
1.1.x
the idea with gateway prefix is that prefix of a gateway is
added in front of the called number when the gateway is used.
thus it does not make sense to have the same gateway in the
same gw group many times with different prefixes.
-- juha