11 Nov
2020
11 Nov
'20
9:28 p.m.
Thanks for your quick response,
Unfortunately add_local_rport() didn't work, but
event_route[tm:loal-request] did work. In the end I manually changed the
header (see below), not the prettiest solution, but it works.
event_route [tm:local-request] {
xlog("L_INFO", "Routing locally generated $rm to $ru\n");
if (is_method("REGISTER")) {
xlog("L_INFO", "Adding rhost parameter to REGISTER
request\n");
# Add rport parameter to Via header
assign_hf_value("Via", "$hdr(Via);rport");
}
}
Thanks again,
Jetse
On Wed, Nov 11, 2020 at 9:42 AM Daniel-Constantin Mierla <miconda(a)gmail.com>
wrote:
Hello,
try to catch uac registrations requests inside
event_route[tm:local-requests] and use add_local_rport() for them -- not
sure it works because I haven't tracked in the code, given that
add_local_rport() was intended for forwarding incoming requests, but it is
a chance it does.
Cheers,
Daniel
On 11.11.20 08:38, Jetse Verschuren wrote:
Hi,
I'm currently trying to connect Kamailio, running in docker, to my
FritzBox. The FritzBox is the modem provided by my ISP, with a builtin voip
server which I can use to dial out (basically a PSTN gateway). In my setup
I have a custom router/firewall/NAT between the FritzBox and the server.
When I connect LinPhone to the FritzBox, from behind the NAT, it works
fine. But when I use the Kamailio uac remote registration, I don't get a
response. After some investigation with wireshark, I found that the the SIP
response from the FritzBox comes on the wrong port, and gets rejected by
the NAT. The request comes from port 1025, but the response is sent to port
5060. I compared the requests from LinPhone and Kamailio, and combined with
some research, found it probably was the rport option in the VIA header.
From what I read, it basically signals the uas to use the source port to
reply to, instead of the port indicated in the request, which would be
necessary to effectively go through a NAT.
After reading a lot of documentation (and even parts of the source), I
wasn't able to find an option to enable this option. Is there some option I
completely missed, or is it not possible? Or am I completely wrong in my
"diagnosis"?
Thanks in advance,
Jetse
_______________________________________________
Kamailio (SER) - Users Mailing
Listsr-users@lists.kamailio.orghttps://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users
--
Daniel-Constantin Mierla -- www.asipto.comwww.twitter.com/miconda --
www.linkedin.com/in/miconda
Funding: https://www.paypal.me/dcmierla