24 Sep
2007
24 Sep
'07
7:12 a.m.
Hi Dan,
Thank you very much. how do I specify the audio file in the dial-peer?
My IOS on the gateway doesn't have
progress_ind alert enable 8 for pots
Once again, thanks a lot.
On 9/24/07, Dan-Cristian Bogos <dan.bogos(a)gmail.com> wrote:
Hey Klaus/Mark,
here is the configuration I have used in the past. It has been a
while, so I do hope I remember it corectly:
In dial-peer voip (the one routing the call coming from pstn to media
streaming source:
dial-peer voice 10000 voip
destination-pattern 10....
progress_ind setup enable 3
This command should force the gateway considering that the call came
from PSTN with a progress indicator = 3 in the setup
message, which
should be interpreted that the originator is non isdn and inband
messages are expected.
Alternatively, one could also force an incoming pots dial-peer match,
which will do some additional work by forcing the cut-through in one
way (progress_ind alert enable 8):
dial-peer voice 1000 pots
destination-pattern 10....
progress_ind setup enable 3
progress_ind alert enable 8
I have found out that in some of the ios-es both commands are marked
as hidden, so don't worry if you don't get them by using the famous
'?' after progress_ind command.
Hope that helps.
Cheers,
DanB
On 9/22/07, Klaus Darilion <klaus.mailinglists(a)pernau.at> wrote:
Dan-Cristian Bogos wrote:
> Hi Guys,
>
> I also have done it and it worked like a charm.
> I could even queue streams (more steps), all being played inband,
> therefore no charge from PSTN side.
> It all depends on your carrier whether he (or his partners) will open
> one way channel on PSTN side or generate his own stuff when receiving
> Progress indicator on ISDN (#C7) side - even Cisco ASes have this
> option built in as a dial-peer command.
>
> Cheers,
> DanB
>
>
> On 9/22/07, Klaus Darilion <klaus.mailinglists(a)pernau.at> wrote:
>> Mark Anthony C. Delfin wrote:
>>> Hi all,
>>>
>>> Is it possible to alter ring back tone on cisco gateways. For
example I
>>> want change my ringback to an audio
file. Some Mobile providers do
this
>>> already.
>>
>> I once tried that too on a 5300 - streaming early media into the
PSTN.
> From
reading the docs I came to the conclusion that it should be
> possible but I could never test it as usually PRI are not allowed to
> stream early media to the PSTN.
Hi Dan! Could you be a be more detailed how this is done in the gateway?
I once did it with a tcl script and it was very complicated.
regards
klaus