2 Feb
2016
2 Feb
'16
10:49 a.m.
Hello,
On 29/01/16 08:26, Barış Şekerciler wrote:
Hello everyone. I'm a student and I'm working
on project which about SIP communication and PBXs with IP phones.
So, my first test results were OK with JITSI. But I think I need Freeswitch for working
with IP phones. In a word, I need configure an integration Kamailio and Freeswitch.
First, I setup Debian 8.3 Jessie and installed Kamailio on this my local server, after
that I installed another Debian 8.3 Jessie (from same image) as my second server and it
was going to run Freeswitch on itself.
Then I tried to send my communication requests to my Freeswitch server. I made some
tests, my Jitsi accounts which are set in Kamailio server were done. I've read
Kamailio 3.2 and Freeswitch integration from the Kamailio wiki and I applied exactly the
same thing but I did not work.
When I tried to reach another IP phone from my IP phone (I registered them) phone always
say "NOT FOUND". I'm sure I did my configuration properly.
So, how can I figure it out these things? How can I understand, does Kamailio routes to
Freeswitch to my phones?
more or less some generic hints on troubleshooting:
- use ngrep or other network traffic sniffer to watch port 5060 and see
the SIP packets
- look at debugger module and enable cfgtrace feature to see what
actions from kamailio.cfg are executed
- use xlog to add log messages where you feel something might not be
correct in the config file and print relevant variables for routing such
as $ru and $du
- eventually run with debug=3, but there can be lots of log messages to
grasp, many not relevant for the issue
- run freeswitch in terminal mode with higher debug level to see what is
doing
Cheers,
Daniel
--
Daniel-Constantin Mierla
http://twitter.com/#!/miconda - http://www.linkedin.com/in/miconda
Book: SIP Routing With Kamailio - http://www.asipto.com
http://miconda.eu