Hi Atle,

Let me make my scenario clear on you.

I have 2 softphone and 1 IP phone(SPA942). I would like to call from Softphone A to SPA942, then use SPA942 transfer the call to Softphone B. But, when I do so, the connection still remained on between SPA942 and Softphone B.

I managed to get Softphone A onHold and the SPA942 managed to call to Softphone B. Once I press on the 'xfer' button after calling Softphone B, A still onHold and no SIP signal to unHold A and to terminate B.

If I would like to configure the ser.cfg file, which part that I need to configure? And how do I do that?

Thanks.

Cheers, Roa Yu

-----Original Message----- From: Atle Samuelsen [mailto:clona@cyberhouse.no] Sent: Thursday, October 11, 2007 3:19 PM To: roayu Cc: serusers@lists.iptel.org Subject: Re: [Serusers] SER + Linksys SPA942 + Call transfer

Hi Roa,i * roayu roayu@ctisys.net [071011 04:01]:

Hi, there!

I have some questions and help.

1. I would like to know can call transfer being done when the

connection is P2P? When I tried to use relay (mediaproxy) to do the call transfer, it's able to transfer the call to the other party whereas when

the

condition is P2P, it just can't pass the correct signal.

I'm proberbly only tierd (9:15 am here) but P2P? Can you provide the signalling and ser.cfg so we can understand what you are trying to establish?

I personally think you are trying to do a call transfer from one ua to a other, where the original call went true mediaproxy, but you do not want the "new" transferd call to go true it.

2. Can SER support SPA942 ? Or is there some other settings that I need

to configure on SER ?

SPA942, SPA962, SPA2102, yea.. all Linksys SPA products work like a charm with SER (Who has a 942 as his primary phone these days)

Best Regards

ATle

Thanks.

Cheers, Roa Yu

---

Serusers mailing list Serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers