Hi,
I am calling from Line1 to Line2 on the same box.
Still, I cannot hear any voice from each other. I have captured the SIP packets, I can see the SIP Request, ACK, BYE, as well as SIP/SDP packets. Everything seems to work properly.
I am using STUN also. If I use serctl ping sip_addr the two lines will response with 200 OK.
So, I don't know what is my problem. Can anyone tell me how to configure this?
Thomas
On Wed, 2004-12-29 at 17:16, Johan Landerholm wrote:
Hi Thomas,
Is UA1 and UA2 on the same device ? The signalling of the call is done between your SPA-2000 and your SER
box,
but when you pickup the phone, the SER box is out of the loop. So, if you're calling between two different devices, you can check the network path between the devices. If you have a firewall that does
NAT,
then this is where you should start. If you try to call from Line1 to Line2 in the same box, your settings would be the first place to start. Ie, what is the contact address of your UA's ? You can check this with the "serctl ul show". The field you should look at is the "Contact" field.
Hope this gets you going...
/Johan
Hi,
I encounter a strange problem when setting up an sip (I am using
sipura
- gateway. I am using ser-0.8.14. I can register UA1 and UA2
with
proxy server. When I try to make a call, phone ringing is heard. However, there is no voice between UA1 and UA2. I hear nothing from
each
other. When I hang up the phone, the call is disconnected.
It seems that though call setup could be established, but voice
packets
cannot be transmitted. What is my problem? Do you have any ideas?
Thank you.
Thomas
Serusers mailing list serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers
-
Thomas