Hi, value of this parameter can be everything, because it is ignored (CVS version). Add modparam("rls", "xcap_root", "http://localhost/xcap") into your config file.

Warning - the presence handbook on ftp://ftp/iptel.org/pub/ser/presence/... describes NOT CVS version but presence snapshot v. 4 which can be downloaded from the FTP too! Module parameters are different and new XCAP module was added.

Vaclav On Tue, May 02, 2006 at 07:42:42AM -0400, Suraj Kumar wrote:

Hi,

I am trying to use IM with ser. Followed the installation procedures as suggested in the presence hand book and running the sample config with db that comes in it but I have the following error in it:
------------------------------------------------
rls_mod_init(): 'xcap_root' not set (global XCAP root)!
 0(21638) init_mod(): Error while initializing module rls
ERROR: error while initializing modules
------------------------------------------------
I have compiled and installed the sip_router from its cvs source but I had ignore one error message sercmd not compiled; not sure if it has anything to do with it.
thanks a lot,
suraj

---

Serusers mailing list serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers