-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
Hi Folks,
I've been experimenting Sipura SPA-2000 and I realised that it doesn't support G.729 in both lines simultaneously.. or be.. when I call to the first line it answers using the preferred codec (G.729) and at the same time I call to the second line and it answer using G711a. I tried to disable other codecs in the second line configuration (just G.729 enable) and tried again and then SPA-2000 answered as busy. I'm using the last firmware version (2.0.10(e)). Anyone have any idea/explanation to solve/about that?
Thanks in advance.
- -- ============================================ Rodrigo P. Telles telles@devel-it.com.br Project Manager Devel-IT - http://www.devel-it.com.br TDKOM Group ============================================
Rodrigo P. Telles writes:
I've been experimenting Sipura SPA-2000 and I realised that it doesn't support G.729 in both lines simultaneously.. or be.. when I call to the first line it answersusing the preferred codec (G.729) and at the same time I call to the second line and it answer using G711a.
the same happened already in some ata's. if i remember correctly, it was due to lack of dsp hardware/cpu cycles, i.e., only one compression coded could be used at the same time. i consider it very bad.
-- juha
Rodrigo P. Telles writes:
I've been experimenting Sipura SPA-2000 and I realised that it doesn't support G.729 in both lines simultaneously.. or be.. when I call to the first line it answersusing the preferred codec (G.729) and at the same time I call to the second line and it answer using G711a.
the same happened already in some ata's. if i remember correctly, it was due to lack of dsp hardware/cpu cycles, i.e., only one compression coded could be used at the same time. i consider it very bad.
-- juha
-
Juha Heinanen -
Juha Heinanen -
Rodrigo P. Telles