On Sunday 02 November 2003 23:06, Akinsola Oyelakin wrote:

Hi Everyone,

I am a newbie to SIP and I have a a network of voice routers (cisco 1760) I normally use full mesh H323. now I want to use SIP and let every voice router get in touch with the SIP server to know the IP address of the destination pattern (number). So the SIP server will be playing the role of a soft PBX. PLEASE help out with what I am suppose to do on the SER and each router. (I have the SER up and running.)

On the CISCO side here's a small example from one of my gws': ... ! ! A simple dial-peer that sends all matching calls ! to the SER box for completion dial-peer voice 7000 voip destination-pattern 7... session protocol sipv2 session target sip-server ! ! ! enable UA functionality on the CISCO box sip -ua ! this is quite obvious ... the IP of your SER server sip-server ipv4:xxx.xxx.xxx.xxx ! ...

That's it for the CISCO side. To test it you may use the default SER config and you should be able to call other UAs registered on the system thru the CISCO gw. One thing that you should remember is that the ser box doesn't register with the SIP server (at leas I haven't found a way to do it) so it will not show up under # serctl ul show

Hope all this helps,

Alex.