Hi, Check library (.so files) paths in ser.cfg file and if not correct, give the correct path for each library. Then run ser again, it will definitely work. Regards, Benjamin.

-----Original Message----- From: Alexandr Dubovikov [mailto:shurik@start4.info] Sent: Thursday, June 08, 2006 5:14 PM To: Shyamsundar, Purkayastha (Purkayastha)** CTR ** Cc: 'serusers@lists.iptel.org' Subject: Re: [Serusers] novice issue

On Thu, Jun 08, 2006 at 04:48:24PM +0530, Shyamsundar, Purkayastha (Purkayastha)** CTR ** wrote:

Hi all

Just started using ser but i am stuck at the first step itself

i downloaded ser-0.9.6_linux_i386.tar

untared it , set the cfg file and modules in correct path as per cfg file and ran ./ser from the sbin directory

and it says

ERROR in cfg file ( 24 errors)

at first, check you configuration with "ser -c"

and set the debug level to 4 in your ser.cfg , after it you can see where is a mistake.

Wbr,