3 Jan
2013
3 Jan
'13
4:14 p.m.
Hi guys,
I have tried to Google this for some time now, but can't seem to find an answer.
Is there a way to read modparam config from a database?
--
Best regards,
Glenn Larsen
4 Jan
4 Jan
4:18 p.m.
Am Donnerstag, 3. Januar 2013, 16:14:59 schrieb Glenn O Larsen:
Hi guys,
I have tried to Google this for some time now, but can't seem to find an
answer.
Is there a way to read modparam config from a database?
Hello,
probably the configuration database module - cfg_db is implementing what you're
searching for. But I personally did not used it so far, so I can't share any
more details.
Best regards,
Henning Westerholt
7 Jan
7 Jan
8:46 p.m.
On Fri, Jan 4, 2013 at 4:18 PM, Henning Westerholt <hw(a)kamailio.org> wrote:
Am Donnerstag, 3. Januar 2013, 16:14:59 schrieb Glenn
O Larsen:
>
> Is there a way to read modparam config from a database?
probably the configuration database module - cfg_db is
implementing what you're
searching for. But I personally did not used it so far, so I can't share any
more details.
Thanks for the tip. Unfortunately it seems that this is only used to
replace the core parameters, not module parameters. At least that's
what my testing, and source code browsing has proven/showed me. If I'm
wrong, please tell.
Based on what I have seen (and tried), it seems that its not possible
to extend this module to set the module parameters, since I can't be
sure that module I'm trying to configure, hasn't been loaded yet. Can
someone with deeper module load knowledge confirm this?
--
Best regards,
Glenn Larsen
8 Jan
8 Jan
9:21 a.m.
7 jan 2013 kl. 20:46 skrev Glenn O Larsen <glenn(a)europlan.no>no>:
On Fri, Jan 4, 2013 at 4:18 PM, Henning Westerholt
<hw(a)kamailio.org> wrote:
In most cases, there should be no need to change modparams at runtime.
Can you tell us more about which parameter you want to change during
runtime that doesn't have a mI/rpc reload command?
/O
Am Donnerstag, 3. Januar 2013, 16:14:59 schrieb
Glenn O Larsen:
>
> Is there a way to read modparam config from a database?
probably the configuration database module -
cfg_db is implementing what you're
searching for. But I personally did not used it so far, so I can't share any
more details.
Thanks for the tip. Unfortunately it seems that this is only used to
replace the core parameters, not module parameters. At least that's
what my testing, and source code browsing has proven/showed me. If I'm
wrong, please tell.
Based on what I have seen (and tried), it seems that its not possible
to extend this module to set the module parameters, since I can't be
sure that module I'm trying to configure, hasn't been loaded yet. Can
someone with deeper module load knowledge confirm this?
4149
days inactive
4154
days old
3 comments
3 participants
participants (3)
-
Glenn O Larsen -
Henning Westerholt -
Olle E. Johansson