hi   i manage the Cisco BTS 10200 system, and now i am assigned a task to work with the Radius i choose the FreeRadius to work with Cisco BTS system modify some config in radiusd.conf & clients.conf first, BTS send message Access Request to FreeRadius and then Freeradius send message Access Accept, they working properly when BTS send message Account Start to Radius, there are a lot attribute and freeradius save them in the radacct table the messages flow: BTS FreeRadius -----Service Authorize------> <-------Access Accept-------- -----Service Start-----------> <-----Account Respone ---- ----Service ReAuthorize----> <-------Account Accept------> -----Service Stop-------------> <-------Account Respone---- but in radacct , there some columm doesn't match with the message Account Start, i want to change the name of some columm to match the message Should i need to edit the sql.conf for this issue On the CDR Tool, should i need to edit to working properly Attribute Vendo Sub Status Attribute Name Type Value ID ID Attribut M- User-Name String ANI 1 ID M- NAS-IP-Address IP ddres BTS IP address 4 M- Service-Type Integer Service Type = Outbound 6 C+ Class String CLASS Attribute 25 M- h323-incoming-conf-id=value String A unique number for identifying a calling session on a gateway, where a session is closed when the calling party hangs up. 26 9 1 M- h323-conf-id String Unique call identifier generated by the BTS. Used to distinguish the separate billable events (calls) within a single calling session. 26 9 24 M- h323-setup-time String hh:mm:ss.mmm ZON DDD MMM ## YYYY Setup time in NTP format. 26 9 25 M+ h323-connect-time String hh:mm:ss.mmm ZON DDD MMM ## YYYY Connect time in NTP format. 26 9 28 C- h323-call-type String Telephony,VOIP 30 27 C+ Called-Station-ID String DNIS 31 M+ Calling-Station-ID Integer ANI 40 M+ Acct-Status-Type String Acct-Status-Type = Start (1) 44 M+ Acct-Session-ID Integer Accounting Session ID 55 M- Event-Timestamp Integer Event Time Stamp 61 M- NAS-Port-Type Integer Ethernet (15) Thanks Ha`