24 May
2016
24 May
'16
7:37 p.m.
Hi Everyone,
What is a accurate way to get current call count. I am only relaying calls.
Initialy I tried the code below. It seemed to work, it reported the correct number of
calls I had dialed. I get the result through kamcmd htable get command.
------------------------------------------
under route[RELAY]
#
# COUNT
#
if (is_method("BYE")) {
$var(n) = $shtdec(callcount=>active);
sht_rm_name_re("callcount=>$ft");
}
--------------------------------------------
# Manage incoming replies
onreply_route[MANAGE_REPLY] {
#
# COUNT
#
if (status=="200") {
if (is_method("INVITE")) {
# On start
if($sht(callcount=>active) == $null) {
$sht(callcount=>active) = 0;
}
# New call
if ($sht(callcount=>$ft::from_tag)== $null) {
$sht(callcount=>$ft::from_tag) = $ft;
$var(n) = $shtinc(callcount=>active);
}
}
xlog("L_INFO", "This is a 200 OK reply\n");
}
xdbg("incoming reply\n");
if(status=~"[12][0-9][0-9]") {
route(NATMANAGE);
}
}
-------------------------------------------------------
However I wanted to distribute calls to several servers
I further added the despatcher code below
# round robin dispatching on gateways group '1'
if(!ds_select_dst("1", "4")) {
send_reply("404", "No destination");
exit;
}
xlog("L_INFO", "-----RELAYING going to <$ru> via <$du>
time [$Tf] -----\n");
This makes my counting code above give incorrect call count.
How can I make call count work with dispatcher ? Do advise how I can do this
Regards