Well, I got the 407 solved - I didn't have my loopback or enet address in the trusted table.
So, I am closer. Next step is to get a B2BUA installed, like rtpproxy to handle the audio, since I don't proxy any audio. Any examples out there where I can initiate the audio for this type of call? Again, I don't currently nor do I want to handle the audio for 'every' call.
Thanks,
-graham
On 10/12/08 12:45 PM, "Graham Wooden" graham@g-rock.net wrote:
Gotcha. Well, I re-ran the capture on another test call and ended the capture a few seconds after I hung up, and still shows the same path.
Ok, here is my proxy_challenge; I put that xlog in it, and sure enough it's entering. Now, I have my provider's IP in my trusted table, so I am not sure why it's challenging...
if (!(method=="REGISTER")) { if (!allow_trusted()) { if (!proxy_authorize("", "subscriber")) { $var(debug) = proxy_authorize("", "subscriber"); xlog("L_INFO", "Proxy authentication failed - M=$rmRURI=$ru F=$fu T=$tu IP=$si ID=$ci\n"); proxy_challenge("", "0"); exit; } fix_nated_sdp("11"); consume_credentials(); # at this point caller is authenticated } }
On 10/12/08 12:32 PM, "Juha Heinanen" jh@tutpro.com wrote:
Graham Wooden writes:
Yeah, I see that 407 Proxy Auth too, but I am not sure where to check for that.
Here is my only challenge statement:
if (is_method("REGISTER")) { if (!www_authorize("", "subscriber")) { www_challenge("", "0"); exit; }407 comes from proxy_challenge. either your config has one or not all packets were shown in capture.
this starts to consume too many cycles that are away from writing code. dig into your config file and make sure that wireshark captures all packets.
-- juha
Users mailing list Users@lists.kamailio.org http://lists.kamailio.org/cgi-bin/mailman/listinfo/users