26 Jun
2004
26 Jun
'04
12:15 p.m.
Bill wrote:
I moved ser from inside my office to a public IP
address. When I use
X-Lite it connects to ser, tries to login anonymously and ser sends back the
Unauthorized packet. When it was in the office X-Lite would then send the
name/password and login. It doesn't do that now.
when starting x-lite it uses STUN to detect the NAT-methode of your
router. Press F9 in xlite to open the debug window. On top of the debug
messages, xlite writes the kind of the detected NAT-style, e.g. in my case:
Discovered Symmetric NAT Firewall
What kind of NAT is the LinkSys router?
I'm using a LinkSys router. When the packet
comes back to the LinkSys
router from ser it hits the LinkSys at port 5060. I don't believe that's
correct but I can't figure out how to correct it.
force_rport in ser.cfg should correct this.
I enabled nathelper but am not sure what to do next.
Also, where is the documentation for the nat_uac_test? I can't find a
single refererence to that in my source code anywhere.
the documentation is sometimes out of date.
http://lists.iptel.org/pipermail/serdev/2003-December/000921.html
you can also take a look at the configuration files in
http://lists.iptel.org/pipermail/serusers/2004-February/005996.html
regards
klaus