Hello all, I installed serweb, it works well, but I have a problem at the level of the application: Another question, if I want to try to make communications between a softphone SIP and an analogical telephone through a cisco router, it is enough to go the commands this below into the cisco router, and the others into the server SER:
In the router:
Dial-peer voice 999 voip Destination-pattern 555999. ** Associate the number arranges 555-9990 to 9999 with our SIP server Session protocol sipv2 ** Set this dial-peer to uses(wears out) SIP instead of Cisco protocols Session target sip-server ** Send the call to our SIP server. See SIP-UA below Codec g711ulaw ** Set the default codec to 711-Ulaw (common codec between customers) ! Sip-ua Sip-server ipv4:192.168.0.1
In the file ser.cfg : if (uri=~"^sip:9[0-9]*@mydomain.com") { ## This assumes that the caller is log("Forwarding to PSTN\n"); ## registered in our realm t_relay_to( "192.168.0.2", "5060"); ## Our Cisco router break; };
thanks you for advance hassan
This mail sent through IMP: http://horde.org/imp/
------------------------------------------------- This mail sent through IMP: http://horde.org/imp/