Re: [SR-Users] Problem initiating a call with dlg_bridge

I seem to be going round in circles… I am trying to use dlg_bridge() from the dialog module to establish a call between two SIP endpoints. I have tested with Snom phones and linphone soft phone with the same result. I get an outbound call to the first (from) end point, I answer the phone… and then nothing obvious happens. I can get this same result when using kamcmd or from within the kamailio.cfg. For example using kamcmd: kamcmd dlg.bridge_dlg sip:105@mykamailioip sip:106@mykamailioip sip:mykamailioip:5060 I expected this to send an invite from "controller" via my KamailioIP to my registered local subscriber 105 (from), and then send a re-invite to 105 so that 105 creates a call leg to 106 (to). The kamailio.cfg is pretty much the default. I am running 4.2 and rtpengine to proxy the RTP streams. Not sure if it is necessary or useful but I call setflag() at the start of the request_route() to set the Dialog flag. What else should I have included in the kamailio.cfg to make this work? Also is there any way to control the SDP in the initial invite from dlg_bridge. By default I see RTP/AVP, with alaw and ulaw…. I’d like to offer RTP/SAVP swell or instead of RTP/AVP. Thanks _______________________________________________ SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list sr-users(a)lists.sip-router.org http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users