Hi to all, We use uac module to use remote registration but when I add a new user to uacreg table the change doesnt take effect until I restart kamailio service which is not convenient for us.Is there another way to achieve this without restarting service? My configuration is below.Am I doing sth wrong? modparam("rr", "enable_full_lr", 1) # do not append from tag to the RR (no need for this script) modparam("rr", "append_fromtag", 1) # ------ uac params ------------------ modparam("uac", "reg_db_url",DBURL) modparam("uac", "reg_timer_interval", 30) modparam("uac", "reg_retry_interval", 60) modparam("uac", "reg_db_table", "uacreg") modparam("uac","restore_mode","auto") modparam("uac", "reg_contact_addr","my ip") modparam("uac","auth_realm_avp","$avp(i:10)") modparam("uac","auth_username_avp","$avp(i:11)") modparam("uac","auth_password_avp","$avp(i:12)") modparam("uac","credential","username:domain:password") modparam("uac","restore_to_avp","$avp(original_uri_to)") modparam("uac","restore_from_avp","$avp(original_uri_from)") failure_route[REMOTE_AUTH]{ xlog("L_INFO","REMOTE_AUTH:$fU:$si$rm:REGISTER"); if ($T_reply_code == 401 or $T_reply_code == 407) { xlog("L_NOTICE", "Remote asked for authentication"); uac_auth(); } } if(is_method("REGISTER")){ xlog("L_INFO","AUTH:$fU:$si$rm:REGISTER:Ru:$rU"); if(uac_reg_request_to("$fU","0")){ xlog("L_NOTICE", "Found remote user [$rU] on [$rd] via [$du]"); t_on_failure("REMOTE_AUTH"); t_relay(); exit; }else{ xlog("L_INFO","AUTH:$fU:$si$rm:REGISTER:else"); if (!auth_check("$fd", "subscriber", "0")) { auth_challenge("$fd", "0"); exit; } } } Thanks in advance.