21 Oct
2005
21 Oct
'05
1:17 p.m.
Daniel-Constantin Mierla wrote:
Hello Ronald,
please use the init.d script to start/stop openser. You can find it
in packaging subdirectory, there are directories for different
distributions and inside of some is a file named openser.init.
Otherwise try starting it from command line:
/usr/local/sbin/openser -f /usr/local/etc/openser/openser.cfg
I used openserctl start and it seems it is different. With
your line above I could start openser in debug mode, however, there is
still no log file about it.
During startup and shutdown many lines flashed through the screen, as
well during CTRL C to stop it. While I try to use sipsak, there was no
extra line on the screen either.
I use SuSE, which init script should I use?
bye
Ronald Wiplinger
Cheers,
Daniel
On 10/20/05 16:44, Ronald Wiplinger wrote:
--
Ronald Wiplinger (CEO of ELMIT)
http://www.elmit.com http://voip.elmit.com http://e-paper.elmit.com
Tel. (M) +886.939.775.516 (O) +886.2.2835.7765 (ENUM) or FWD 511208
- I'm a SpamCon Foundation Member, #694, Verify it at http://www.spamcon.org
PS: Spam prevention!
Our system is protected with a spam prevention program.
If you send us an e-mail, our system will send you a confirmation message back. Just reply
to this confirmation message please.
After receiving this confirmation message, our system will send the hold message (one) and
all future messages (after the received confirmation message) to me without asking you
again.
Bogdan-Andrei Iancu wrote:
Hi,
this is rather strange - can you post the error messages generated
by openser at startup?? (see syslog)
With debug it DOES NOT START, no messages in /var/log/messages
It hangs at the line:
Starting OpenSER :
Without debug the only message during startup is:
Oct 20 21:41:00 vpbx /usr/local/sbin/openser[3882]: Maxfwd module-
initializing
bye
Ronald Wiplinger
regards,
bogdan
Ronald Wiplinger wrote:
Bogdan-Andrei Iancu wrote:
> Hi Ronald,
>
> to find why your authentication fails, run openser in debug mode
> (debug=7) and look into the logs for hints. If you have doubts,
> just post the log.
>
Hi,
with:
debug=7 # debug level (cmd line: -dddddddddd)
#fork=yes
#log_stderror=no # (cmd line: -E)
/* Uncomment these lines to enter debugging mode */
fork=no
log_stderror=yes
/* */
in openser.cfg openser does not start at all.
The picture shows:
vpbx2:/usr/local/etc/openser # openserctl start
Starting OpenSER :
Thanks for your help!
bye
Ronald Wiplinger