27 Mar
2007
27 Mar
'07
1:23 a.m.
Hi Toni,
Maybe this will help you:
http://www.voice-system.ro/docs/ser-syslog/ar01s06.html
Check the Note at the end of the page:
NOTE: The '-' in front of "/var/log/ser.log" is to omit synchronizing
the log file after every log message. If you choose to configure
"syslog" in synchronous mode you must be aware that it has big impact
over performances when the signaling traffic is high.
Regards,
Ovidiu Sas
On 3/26/07, Toni Barata <toni-r-barata(a)ptinovacao.pt> wrote:
Hi Daniel,
Increasing the children from 4 to 16 did turn into same results (I was already using
debug=3 and fork=yes).
But setting debug=0 did real turn in much better results.
Thanks a lot,
Toni
-----Original Message-----
From: Daniel-Constantin Mierla [mailto:daniel@voice-system.ro]
Sent: segunda-feira, 26 de Março de 2007 16:53
To: Toni Barata
Cc: users(a)openser.org
Subject: Re: [Users] load testing presence server
Hello,
if you use exactly the same config, then turn debug to a lower level
(e.g., 3), set fork=yes and children to 16 for better results.
Cheers,
Daniel
On 03/26/07 18:48, Toni Barata wrote:
Hi Anka,
In a scenario using Openser as a Presence Sever (using the config file
example located in
http://openser.org/dokuwiki/doku.php/presence:configuration-file), the
execution of load tests (with sipp) with Subscribe Presence WInfo had
as result a maximum of 20 sessions per second (We are using a Intel(R)
Xeon(TM) CPU 3.00GHz with 2GB RAM), with lots of retransmissions if we
increase to values bigger than 20 (Openser dos not crash). Is there
any configurable parameter in the Presence module that allows
increasing this value?
Best regards,
Toni
------------------------------------------------------------------------
_______________________________________________
Users mailing list
Users(a)openser.org
http://openser.org/cgi-bin/mailman/listinfo/users
_______________________________________________
Users mailing list
Users(a)openser.org
http://openser.org/cgi-bin/mailman/listinfo/users