SER's CVS HEAD version has this fetaure...I guess you would have to use t_on_failure and such...
Samuel
2006/9/25, Kostas Marneris K.Marneris@otenet.gr:
thanks. This works Ok.
I have one more question : My DNS SRV config is something like that :
$ORIGIN pstngw.foo.com. _sip._udp SRV 1 1 5060 pstn1.foo.com. SRV 1 1 5060 pstn2.foo.com.
I can load balance (50-50) with the above.
But if one of the GWs is down, then SER keeps on doing "load balancing 50-50" , so the ~50% of the calls are routed to GW that is down .
Is there a way to have a redundancy setup with DNS SRV only (with 50-50 load balancing) ? Does this supported by SER's DNS SRV implementation (t_relay() ) ?
Or do I have to handle this issue with the t_on_failure() mechanism ?
thanx. Kostas
Greger V. Teigre wrote:
Use rewritehost("pstngw.foo.com"); (If port is specified, DNS SRV is not used, ref. the RFC) g-)
Kostas Marneris wrote:
Hello,
I run ser.0.9.6 and I can use either rewritehostport("1.2.3.4:5060"); or rewritehostport("pstngw.foo.com:5060");
with t_relay() command on INVITE/PSTN handler in order to route calls to a Cisco PSTN GW. This works fine.
Is "DNS SRV queries" supported on ser.0.9.6 and is there a specific conf ?
thanx Kostas _______________________________________________ Serusers mailing list Serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers
Serusers mailing list Serusers@lists.iptel.org http://lists.iptel.org/mailman/listinfo/serusers