7 Nov
2005
7 Nov
'05
8:17 a.m.
Here is the segment of config file where the errors occur:
switch(retcode){
case 1:
xlog("L_ERR","Has been selected the 1
index");
route(1);
break;
case 2:
xlog("L_ERR","Has been selected the 2
index");
route(2);
break;
}
xlog("L_ERR","Destination uri [$du]");
The error of buffer overflow appears only inside the switch routine.
The last log, Destination uri, appears without any problem.
It's quite extrange.
2005/11/7, Bogdan-Andrei Iancu <bogdan(a)voice-system.ro>ro>:
Hi Jose,
seams to be a problem is xlog. Does the error appear only in case + xlog
configuration, or that xlog call, whatever his place is, produces the error?
regards,
bogdan
Jose Maria Gonzalez wrote:
--
Salu2:
***************************************
José María González
***************************************
I have installed openser v1.0 and it is working
perfectly. But I have
a problem with the xlog module. Many times I've got the following
error:
Nov 7 11:28:34 localhost openser[1736]: xl_printf: buffer overflow --
increase the buffer size...
The line that produces this error is this (it is inside a case stament):
xlog("L_ERR","Has been selected the 1 index");
I have tried to increase the buffer size in the following form:
modparam("xlog","buf_size",8192)
No matters the size that I put on the line buf_size, I always get the
same error.
I thing that a buffer size of 8kb should be enough for this log
message, isn't it?
Thanks.
--
Salu2:
***************************************
José María González
***************************************
_______________________________________________
Users mailing list
Users(a)openser.org
http://openser.org/cgi-bin/mailman/listinfo/users