Re: [Users] lcr, branch route and setdsturi

Hi, Is it possible to set the dst-uri in a branch-route (in openser 1.1)? It would be useful if you could for example do least-cost-routing with lcr, where some of the gateways need an extra hop via an outbound-proxy, which could be marked with a prefix in the gw-table, like: route[1] { # let's assume uri = 'sip:12345@something' load_gws(); next_gw(); # lcr module selects a gw according to lcr patterns, and some of # them needs an outbound-proxy, which are marked by prefix 'out' t_on_failure("1"); t_on_branch("1"); # do something else and t_relay() } failure_route[1] { if( /* error code which triggers failover */ ) { if(next_gw()) { t_on_branch("1"); t_on_failure("1"); t_relay(); } else { /* error */ } } } branch_route[1] { # check if it's marked for using an outbound proxy: if(uri =~ "^sip:out[0-9]+@") setdsturi("sip:my.outbound.ip:5060"); } Would this work? Comments? Regards, Andreas This e-mail is confidential and may well also be legally privileged. If you have received it in error, you are on notice of its status. Please notify us immediately by reply e-mail and then delete this message from your system. Please do not copy it or use it for any purposes, or disclose its contents to any other person: to do so could be a breach of confidence. Thank you for your cooperation. Information pursuant to paragraph 14 Austrian Companies Code: UPC Austria GmbH; Registered Office: Wolfganggasse 58-60, 1120 Vienna Company Register Number: FN 189858d at the Commercial Court of Vienna _______________________________________________ Users mailing list Users(a)openser.org http://openser.org/cgi-bin/mailman/listinfo/users