28 Jan
2008
28 Jan
'08
1:15 p.m.
Hi Victor,
Victor Gamov wrote:
Klaus Darilion wrote:
$dP and $dp are looking into destination uri ($du) which is an URI you
set as outbound proxy. So t_relay() will not set this pvars.
just to be clear, the variables do not contain information about where
the message will be sent (at IP level), but where the message should be
sent (outbound proxy). This is information passed to the t_relay()
function and not information provided by t_relay().
Regards,
Bogdan
Victor Gamov schrieb:
I see.
And in this situations $dP implicitly set to 'UDP' and $dp explicitly
set to '8888', yes ?
Another question: is it possible that t_relay() set this variables
because t_relay() really know which $dP & $dp was used to send request.
Hi gentlemen!
I use openser-1.2.2 and I want to access to dp & dP variables but
sometimes they are empty. I try to access it before and after
t_relay() and result is the same -- variable is empty.
When this variables are set?
Manually in openser.cfg or by some functions (e.g. lookup() or
loose_route()).
Is it possible that they are not set at all?
yes.
If openser forwards the request (e.g. t_relay) it verifies if DURI is
set. If yes, the request is sent to the DURI.
If DURI is not sent, the request is forwarded to the RURI.
a typical example: client behind NAT register with Contact URI
sip:192.168.2.2:5060. The request comes from 1.2.3.4:8888.
Then during save openser will save the contact and the public address.
Further, if you lookup() this user, the lookup function will set RURI
to sip:192.168.2.2:5060 and duri to sip:1.2.3.4:8888