Did you load the module?
On Thursday, January 3, 2019 5:27:12 PM EST Andrew Chen wrote:
Hey it's me again.
So I'm following the instructions in the Kamailio 5.1.x wiki module page for websocket configuration and it specifically mention to set this block:
onreply_route[WS_REPLY] { xlog("L_INFO", "[CSeq $cs] Is in WS_REPLY."); xlog("L_INFO", "[CSeq $cs] Sending $rs $rr to $sel(via[2].host) via $sel(via[2].transport) len: $ml"); xlog("L_INFO", "[CSeq $cs] \n$mb \n");
if(nat_uac_test("64")) { # Do NAT traversal stuff for replies to a WebSocket connection # - even if it is not behind a NAT! # This won't be needed in the future if Kamailio and the # WebSocket client support Outbound and Path. add_contact_alias(); } }
When I did this and started up Kamailio, it gave me an error:
Jan 3 22:19:43 sjomainkama55 kamailio: ERROR: <core> [core/cfg.y:3309]: yyparse(): cfg. parser: failed to find command nat_uac_test (params 1)
I moved that if statement to a route block and I was able to start it up.
The wiki page for nathelper module specify this function can be run in onreply_route as well:
5.5. nat_uac_test(flags) Tries to guess if client's request originated behind a nat. The parameter determines what heuristics is used. Meaning of the flags is as follows: 1 - The “Contact” header field is searched for occurrence of RFC1918 or RFC6598 addresses. 2 - the "received" test is used: address in the “Via” header is compared against source IP address of signaling 4 - The Top Most “Via” is searched for occurrence of RFC1918 or RFC6598 addresses 8 - The SDP is searched for occurrence of RFC1918 or RFC6598 addresses 16 - Test if the source port is different from the port in the “Via” header 32 - Test if the source IP address of signaling is a RFC1918 or RFC6598 address 64 - Test if the source connection of signaling is a WebSocket 128 - Test if the “Contact” header URI port differs from the source port of the request (Warning: this is might be legal or even intended combination in non NATted scenarios) All flags can be bitwise combined, the test returns true if any of the tests identified a NAT. This function can be used from REQUEST_ROUTE, ONREPLY_ROUTE, FAILURE_ROUTE, BRANCH_ROUTE.
is this some known bug in 5.1.x? Thanks