8 Aug
2010
8 Aug
'10
2:02 p.m.
Hello List,
finally I figured out, why the previously described problem exists (avps
declared in request route are not available anymore in branch route, if
pua_dialoginfo module is loaded).
pua_dialoginfo uses pua for sending PUBLISH request
pua uses tm t_request for sending PUBLISH request
t_request() is located in uac.c (tm):
- in line 411 avp list is reset
- in line 276 build_cell() is called:
build_cell() is located in h_table.c, where lines 305-323 delete avps
If I comment out the mentioned lines, which delete avps, then avps set
in request route are also available in branch route.
But I do not know, what is also affected by this change.
Do you have some ideas, may we find a good solution for that?
Regards
Jasmin
Hi Henning,
because of the fact, that the problem only appears, if the
pua_dialoginfo module is enabled, I think the problem is located
somewhere in the code tm hooks, dialog hooks or pua/pua_dialoginfo
itself...
I have attached the debug output of pua_dialoginfo which shows only, if
the module is enabled... may it is useful in any way...
Regards
Jasmin
On Friday 04 June 2010, Jasmin Schnatterbeck
wrote:
_______________________________________________
sr-dev mailing list
sr-dev(a)lists.sip-router.org
http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-dev onreply_avp_mode does not seem to be available in
kamailio 3.0.2 (at
least not in the module doc)
I think this parameter is for avps in reply_route? or does it work for
branch_route also?
Hi Jasmin,
ah, sorry. Its not available or necessary anymore in 3.0. In 1.5 it also
affected the branch_route, i think, but for the newer version this behaviour
is now the default. Then in your case its probably another problem..
Cheers,
Henning