[SR-Users] BLF 'NOTIFY' not working

Wed Oct 2 14:00:45 CEST 2019

I decided to try a different setup and install Siremis and Kamailio 5.1 according to the following tutorial :
https://www.powerpbx.org/content/kamailio-v5-siremis-v5-debian-v9-mariadb-apache-v1

All is working and because this setup uses WITH_NAT, I have not needed to add set_contact_alias() to the SUBSCRIBE section of kamailio.cfg.

Unfortunately, the BLF lights on the phone do not light up. I can see dialog entries in the "Active Watchers List" in Siremis and no errors in the log. The other list ("Watcher List", "Presentity List" and "PUA List") are empty.

I have tested the phone directly with Freeswitch to make sure the lights are working.

Any ideas.

________________________________
From: sr-users <sr-users-bounces at lists.kamailio.org> on behalf of Petarr Jones <petarrjones at outlook.com>
Sent: 01 October 2019 06:29
To: Kamailio (SER) - Users Mailing List <sr-users at lists.kamailio.org>; miconda at gmail.com <miconda at gmail.com>
Subject: Re: [SR-Users] BLF 'NOTIFY' not working

Daniel

Adding in the set_contact_alias() for SUBSCRIBE meant that the NOTIFY now gets a "200 OK", but the light on the phone does not light up even though the extension being monitored is registered.

I notice that after the SUBSCRIBE request, the return message is a "202 OK" instead of a "202 ACCEPTED". Is that correct?

I am also now getting this message in the log

nathelper [nathelper.c:700]: set_contact_alias(): you can't update contact twice, check your config!
________________________________
From: sr-users <sr-users-bounces at lists.kamailio.org> on behalf of Petarr Jones <petarrjones at outlook.com>
Sent: 01 October 2019 02:57
To: Kamailio (SER) - Users Mailing List <sr-users at lists.kamailio.org>; miconda at gmail.com <miconda at gmail.com>
Subject: Re: [SR-Users] BLF 'NOTIFY' not working

Thanks for your response Daniel.

Kamailio is installed on a cloud server (not AWS) and therefore has an internet facing IP address. The phone is in my office so there is NAT happening at that end. I would have thought the NAT traversal would only apply if the server/Kamailio was behind a firewall/router doing some kind of NAT?

Regards
Petarr
________________________________
From: Daniel-Constantin Mierla <miconda at gmail.com>
Sent: 01 October 2019 00:16
To: Kamailio (SER) - Users Mailing List <sr-users at lists.kamailio.org>; Petarr Jones <petarrjones at outlook.com>
Subject: Re: [SR-Users] BLF 'NOTIFY' not working

Hello,

there can be NOTIFY requests with no body, as the one below has Content-Length 0 -- a matter of what is the call state, it can be a valid one.

Regarding the fact that the NOTIFY is not delivered, have you done nat traversal for SUBSCRIBE? I see private address in the R-URI, so the problem can be in that part. You should do set_contact_alias() for SUBSCRIBE.

Cheers,
Daniel

On 30.09.19 15:16, Petarr Jones wrote:
Hi

I am using Kamailio 5.2 with the following PRESENCE modules and parameters:

loadmodule "presence.so"
loadmodule "presence_xml.so"
loadmodule "presence_dialoginfo.so"
loadmodule "presence_reginfo.so"

modparam("presence", "db_url", DBURL)
modparam("presence_xml", "db_url", DBURL)
modparam("presence_xml", "force_active", 1)
modparam("presence_xml", "disable_bla", 0)
modparam("presence_xml", "integrated_xcap_server", 1)

I have a Yealink T28P phone which has two lines/extensions successfully registered with Kamailio 5.2. When I setup the BLF light to monitor one of the extensions, I get the correct SUBSCRIBE record but the NOTIFY record is sent over and over again until it fails.

-----------------------------------------------------------------------------------------------------------
NOTIFY sip:101 at 192.168.1.123:5062 SIP/2.0
Via: SIP/2.0/UDP 45.45.45.45;branch=z9hG4bKd16c.03b5bc97000000000000000000000000.0
To: <sip:101 at 45.45.45.45><sip:101 at 45.45.45.45>;tag=1366853594
From: <sip:104 at 45.45.45.45><sip:104 at 45.45.45.45>;tag=a6a1c5f60faecf035a1ae5b6e96e979a-e6c3
CSeq: 2 NOTIFY
Call-ID: 594386350 at 192.168.1.123<mailto:594386350 at 192.168.1.123>
Content-Length: 0
User-Agent: kamailio (5.2.4 (x86_64/linux))
Max-Forwards: 70
Event: dialog
Contact: <sip:45.45.45.45:5060;transport=udp><sip:45.45.45.45:5060;transport=udp>
-----------------------------------------------------------------------------------------------------------

When I register the phone with Freeswitch instead and run the same test, the NOTIFY works and I get a much longer NOTIFY message

-----------------------------------------------------------------------------------------------------------
NOTIFY sip:100 at 192.168.1.123:5064 SIP/2.0
Via: SIP/2.0/UDP 66.66.66.66;rport;branch=z9hG4bK1mXej9r2605UB
Route: <sip:55.55.55.55:5064><sip:55.55.55.55:5064>;transport=udp
Max-Forwards: 70
From: <sip:102 at 66.66.66.66><sip:102 at 66.66.66.66>;tag=xUoVghM5syHc
To: "100" <sip:100 at 66.66.66.66><sip:100 at 66.66.66.66>;tag=1720892352
Call-ID: 2583553127 at 192.168.1.123<mailto:2583553127 at 192.168.1.123>
CSeq: 1178415701 NOTIFY
Contact: <sip:102 at 66.66.66.66:5060><sip:102 at 66.66.66.66:5060>
User-Agent: FreeSWITCH-mod_sofia/1.10.1-release-12-f9990221e6~64bit
Allow: INVITE, ACK, BYE, CANCEL, OPTIONS, MESSAGE, INFO, UPDATE, REGISTER, REFER, NOTIFY, PUBLISH, SUBSCRIBE
Supported: timer, path, replaces
Event: dialog
Allow-Events: talk, hold, conference, presence, as-feature-event, dialog, line-seize, call-info, sla, include-session-description, presence.winfo, message-summary, refer
Subscription-State: active;expires=1800
Content-Type: application/dialog-info+xml
Content-Length: 149

xml version="1.0"?>
dialog-info xmlns="urn:ietf:params:xml:ns:dialog-info" version="0" state="full" entity="sip:102 at 66.66.66.66"<sip:102 at 66.66.66.66>>
dialog-info>
-----------------------------------------------------------------------------------------------------------

Should the message coming from Kamailio contain more data or is that not the issue. Should I be including other modules also?

All guidance would be appreciated.

_______________________________________________
Kamailio (SER) - Users Mailing List
sr-users at lists.kamailio.org<mailto:sr-users at lists.kamailio.org>
https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users

--
Daniel-Constantin Mierla -- www.asipto.com<http://www.asipto.com>
www.twitter.com/miconda<http://www.twitter.com/miconda> -- www.linkedin.com/in/miconda<http://www.linkedin.com/in/miconda>
Kamailio Advanced Training, Oct 21-23, 2019, Berlin, Germany -- https://asipto.com/u/kat
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.kamailio.org/pipermail/sr-users/attachments/20191002/c26df4c0/attachment.html>