[SR-Users] Doubs about using append_branch ...

[Raúl Alexis Betancor Santana]

On Monday 26 July 2010 07:02:03 Alex Balashov wrote:
> On 07/26/2010 01:59 AM, Raúl Alexis Betancor Santana wrote:
> > On Monday 26 July 2010 06:21:56 Alex Balashov wrote:
> >> On 07/26/2010 01:20 AM, Raúl Alexis Betancor Santana wrote:
> >>> On Monday 26 July 2010 04:32:13 Iñaki Baz Castillo wrote:
> >>>> El día 26 de julio de 2010 01:07, Raúl Alexis Betancor Santana
> >>>>
> >>>> <rabs at dimension-virtual.com>   escribió:
> >>>>> any clue or example about how to work with the new branch ONLY ? ...
> >>>>> because branch 1 works ok, I need to do changes only on branch 2
> >>>>
> >>>> You must inspect the $ru (or $du depending the case) in
> >>>> onbranch_route, and take the desired action when $ru is
> >>>> $avp(s:followme).
> >>>
> >>> Umm ... again confused ... does the execution of the cfg continues
> >>> AFTER the append_branch call,just on the next line ... or it "begins"
> >>> on "t_on_branch()"?
> >>
> >> The first one.
> >
> > So ... both branches continues at the same point, with the only
> > difference that one have $ru = $avp(s:followme) ... uff ... I'll have to
> > elavorate a little more because that point of the .cfg it's also reached
> > with a "normal" call to $avp(s:followme) ...      :-\
>
> It might be more helpful to think of it as: execution continues right
> where it was in the request route, but a branch route is also later
> called right before the message is forwarded on the given branch, not
> in parallel, where certain branch-specific parameters can be tweaked
> at the last moment, or certain branch-specific actions taken.

I don't undestand ... so ... execution continues in the next line, just after 
append_branch for BOTH branches, but wenever I call t_relay ... BOTH branches 
will pass through on_branch_route BEFORE been forwarded?

-- 
Raúl Alexis Betancor Santana
Dimensión Virtual