[Serusers] novice issue

[Benjamin.George at t-systems.com]

Hi,
Check library (.so files) paths in ser.cfg file and if not correct, give the correct path for each library. Then run ser again, it will definitely work.
Regards,
Benjamin.


-----Original Message-----
From: Alexandr Dubovikov [mailto:shurik at start4.info] 
Sent: Thursday, June 08, 2006 5:14 PM
To: Shyamsundar, Purkayastha (Purkayastha)** CTR **
Cc: 'serusers at lists.iptel.org'
Subject: Re: [Serusers] novice issue

On Thu, Jun 08, 2006 at 04:48:24PM +0530, Shyamsundar, Purkayastha (Purkayastha)** CTR ** wrote:
> Hi all
> 
> Just started using ser but i am stuck at the first step itself
> 
> i downloaded ser-0.9.6_linux_i386.tar 
> 
> untared it , set the cfg file and modules in correct path as per cfg file 
> and ran ./ser from the sbin directory 
> 
> and it says
> 
> ERROR in cfg file ( 24 errors)

at first, check you configuration with "ser -c"

and set the debug level to 4 in your ser.cfg , after it you can see where is a
mistake.


Wbr,
-- 
Alexandr Dubovikov * baron at iRC RusNet * mailto:shurik at start4.info
    AD1-UANIC      *  ICQ: 122351182  *  http://www.start4.info
_______________________________________________
Serusers mailing list
Serusers at lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers