[Serusers] t_relay results in 483 error

[Marian Dumitru]

Hi Pat,

Set as alias the domain name (as DNS name). If your requests look like 
user at foo.org, set  alias=foo.org

Best regards,
Marian

pat newham wrote:
> Thank you for reply. It is still not working correctly
> Im afraid.
> 
> I have added the lines :
> 
> alias= xxx.xxx.xxx.xxx (being the public address of my
> ser server)
> alias =127.0.0.1
> 
> at the start of the config file and added
> 
> if (uri==myself)
> {
>     bla
> }
> 
> in the middle of my config.
> 
> Other than that my config is just the default one. As
> I mentioned previously I have both user agents and ser
> on public addresses. There is no nat or even
> authentication in the current setup. It is the
> simplest scenario, they are all connected via a hub
> and all have public addresses.
> 
> A sniff of the eth0 i/f of ser revealed:
> 
> an invite going from UA1 to SER. A 100 trying message
> sent back to UA1. Then a 483 too many hops message
> sent from ser to UA1.
> 
> A sniff of the loopback i/f revealed an invite message
> sent from ser address to ser address repeatedly.
> 
> Any further ideas?
> Thank you,
> Pat.
> 
>  --- Marian Dumitru <marian.dumitru at voice-sistem.ro>
> wrote: 
> 
>>Hi Pat,
>>
>>Most sure "uri==myself" doesn't match for your RURI
>>domain. Be sure SER 
>>consider as served domain the RURI domain. At
>>startup you see the 
>>listing of all served domains by SER. If you want to
>>add some more, use 
>>the alias config option:
>>	alias=some.new.domain
>>
>>Best regards,
>>Marian
>>
>>pat newham wrote:
>>
>>>Hello,
>>>
>>>I am new to this list and SEr and am trying a very
>>>simple scenario. I would like to establish a call
>>>using SER via two grandstream BT100's(UA1 and
>>
>>UA2).
>>
>>>The two agent and SER are all on public addresses.
>>
>>The
>>
>>>two agents register with SER ok. However when I
>>
>>try to
>>
>>>ring UA2 from UA1, I get a 483 error. I know that
>>
>>this
>>
>>>mean there are too many hops. My config is
>>
>>practically
>>
>>>the same as the basic (i.e. standard)configuration
>>>file (except for authorization and I have added a
>>
>>line
>>
>>>including an alias equal to the public address of
>>>ser....the "if (uri==myself)" statement is correct
>>
>>I
>>
>>>think...I checked). 
>>>
>>>I checked the loopback address as suggested in the
>>>archives and can see that the invite is repeatedly
>>>sent to ser itself and 100 trying messages are
>>
>>sent to
>>
>>>ser itself, therefore the max forwards value value
>>>must be reached and this is why the error occurs.
>>>
>>>I note that when I comment out all the t_relay()'s
>>
>>in
>>
>>>ser.cfg, the error doesnt occur however the invite
>>>from UA1 reached ser and thats it.(i.e. its not
>>>forwarded)...Any help would be greatly
>>
>>appreciated(I
>>
>>>run the most stable version of ser released i.e
>>>0.8.14)
>>>
>>>Regards,
>>>Pat.
>>>


-- 
Voice System
http://www.voice-system.ro