[Users] help: using mediaproxy
unplug
maillisting at gmail.com
Thu Dec 22 04:17:22 CET 2005
Thanks klaus.
After getting your clue, I have fixed, I think, the problem. As you
mentioned, I have inserted the IP in the domain table. Moreover, I
have remarked line 238 from the original document to exclude one of
the use_media_proxy(). It seems to work fine. Next, I will move on
the call forwarding.
On 12/19/05, Klaus Darilion <klaus.mailinglists at pernau.at> wrote:
> unplug wrote:
> > Hi,
> > I am using the example "gw-pstn" from Getting started. I followed
> > the guide to setup mediaproxy for handle NAT function. However, I
> > can't make call between Internal IPphone to PSTN. Anyone can help me
> > to analyze why it doesn't work.
> >
> > After using mediaproxy, I found that some data are stored in the table
> > "Location" compared not using mediaproxy. The field "contact"
> > contains "sip:number at internalIP:port" and the field "received"
> > contains "sip:externalIP:port". Is it correct after using mediaproxy?
> >
> > I have a look for the log from ngrep and some extra parameters "rport
> > and receieved" in the header.
> >
> > When I try to make a call from internal IP phone to PSTN, the error
> > "500 FQDN in SDP Media cannot be resolved.". I think it is still a
> > NAT problem and it seems to use the internal IP instead of external
> > IP. As the same time, Cisco shows (no route to destination (3)).
> >
> > When I try to make a call from PSTN to internal IP phone, the error "
> > Too Many Hops", which is the error message in the openser.cfg file,
> > shown. I do think it is the same reason as the above case.
>
> Probably openser does not recognize that it should handle the SIP
> request thus it forwards it (again to itself).
>
> You will see the looped requests when sniffing on the loopback device
> too: ngrep -d any port 5060
>
> This is a problem if uri=myself does not match
>
> If you are using the domain module, maybe you have to add the IP address
> of openser into the domain table. You could also use is_from_gw from lcr
> module to detect requests from your gateway.
>
>
> regards
> klaus
>
>
>
More information about the sr-users
mailing list