[Users] ruri, dset, branches ...
Bogdan-Andrei Iancu
bogdan at voice-system.ro
Tue Aug 23 08:55:06 CEST 2005
Hi Richard,
Richard Z wrote:
>>>Can you please describe the difference of these variables?
>>>
>>>
>>- a branch is an address other than R-URI that should replace R-URI in
>>the message in case of parallel or serial forking
>>- all branches pseudo-variables is a comma separated list of the
>>branches set for the message
>>- destination set is the list of all addresses that will be set as R-URI
>>for the SIP message (case of serial or parallel forking). This includes
>>the R-URI and branches.
>>- destination uri is the address where the message is to be sent (the
>>outbound proxy, next hop -- if it is not set, then the message is sent
>>based on R-URI address). Note that for each branch you can have a uri to
>>put as R-URI and an address as dst_uri
>>- request uri is the address in the first line of a SIP request, after
>>the SIP method ( ;-) )
>>
>>
>
>That brings on another question, what does avp_write($ruri,"i:100")
>use after lookup? dst-uri or branches?
>
>
will be the RURI.
regards,
bogdan
More information about the sr-users
mailing list