[Serusers] Manipulate wrong REGISTER URIs from UAs

[Marian Dumitru]

Hi Alex,

Have you enabled "use_domain" parameter for usrloc module? If you set it 
to 0 (as default) usrloc will not use the domain part to perform usrloc 
  lookup.

Best regards,
Marian Dumitru

Alex Mack wrote:
> Hi!
> 
> I'm using ser with X-Ten Lite Soft-UA and Siemens optiPoint 400 IP 
> phones. Problem is: the Siemens phones don't register themselves correctly.
> 
> For example:
> (e.g., ser has IP 100.100.100.100)
> 
> Soft-UA is "sip:30 at mydomain.org"
> Phone 1 is "sip:31 at mydomain.org"
> Phone 2 is "sip:32 at mydomain.org"
> 
> Soft-UA registers itself as "sip:30 at mydomain.org"
> Phone 1 registers itself as "sip:31 at 100.100.100.100" (seems to be odd 
> behaviour)
> Phone 2 registers itself as "sip:32 at 100.100.100.100"
> 
> But now the lookup fails if you start dialing from the phones. If you 
> dial "32" (e.g. from Phone 1), the phone generates an INVITE to 
> "sip:32 at mydomain.org" which can't be found in usrloc (DEBUG tells that) 
> and the call fails. If you dial "30" from the same phone, the call comes 
> through, because "sip:30 at mydomain.org" was found in usrloc.
> I tried to mangle the uri in the REGISTER message before 
> "save("location");", without effect. I've used "replace(re, str)", but 
> it didn't seem to work.
> 
> Any ideas to overcome that bug of the phones?
> 
> Thanks!
> Alex.
> 
> _______________________________________________
> Serusers mailing list
> serusers at lists.iptel.org
> http://lists.iptel.org/mailman/listinfo/serusers
> 

-- 
Voice Sistem
http://www.voice-sistem.ro