[Serusers] as5400 and ser
CM Rahman
cmrahman at ccsi.com
Fri Jun 25 22:32:09 CEST 2004
Once I send a call via messenger, I don't hear anything other side. But
after a while it disconnect.
Here are the cisco config
******************************
controller T1 7/0:3
framing esf
pri-group timeslots 1-24
description Prism Test
***************************************
interface Serial7/0:3:23
no ip address
isdn switch-type primary-ni
isdn protocol-emulate network
isdn incoming-voice modem
isdn T310 180000
no cdp enable
!***************************************
dial-peer voice 150 voip
description CCSi voip phone
destination-pattern 9T
session protocol sipv2
session target ipv4:216.236.160.11
codec g723r53
*****************************************
*Feb 15 16:18:09.720: ISDN Se7/0:3:23 Q931: Applying typeplan for
sw-type 0xD is 0x2 0x1, Called num 5122200090
*Feb 15 16:18:09.720: ISDN Se7/0:3:23 Q931: TX -> SETUP pd = 8 callref
= 0x002E
Bearer Capability i = 0x8090A2
Standard = CCITT
Transer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98381
Exclusive, Channel 1
Called Party Number i = 0xA1, '5122200090'
Plan:ISDN, Type:National
*Feb 15 16:18:09.732: ISDN Se7/0:3:23 Q931: RX <- CALL_PROC pd = 8
callref = 0x802E
Channel ID i = 0xA98381
Exclusive, Channel 1
*Feb 15 16:20:17.967: ISDN Se7/0:3:23 Q931: TX -> DISCONNECT pd = 8
callref = 0x002E
Cause i = 0x8290 - Normal call clearing
*Feb 15 16:20:17.995: ISDN Se7/0:3:23 Q931: RX <- RELEASE pd = 8
callref = 0x802E
*Feb 15 16:20:17.995: ISDN Se7/0:3:23 Q931: TX -> RELEASE_COMP pd = 8
callref = 0x002E
&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*
C.M. Rahman Jr.
CCNP, MCSE Security "Secure your self by securing your System"
CompTI Security Plus Certified
CCS Internet
http://www.ccsi.com
13704 Research Blvd. Building O-Suite 4
Austin, TX 78750
Tel: 512-257-2274 Ex: 115
-----Original Message-----
From: serusers-bounces at iptel.org [mailto:serusers-bounces at lists.iptel.org] On
Behalf Of Richard
Sent: Friday, June 25, 2004 3:27 AM
To: serusers at lists.iptel.org
Subject: RE: [Serusers] as5400 and ser
If you check this page,
http://www.cisco.com/en/US/tech/tk652/tk701/technologies_configuration_g
uide_chapter09186a00800eadfa.html
PSTN error "63 Service or option unavailable" is
mapped to sip error "503 Service or option
unavailable" which is in the header of the message.
Also the page shows why IP phone or PSTN generates
this and how proxy is supposed to do with it. Quote,
"The SIP gateway generates this response if it is
unable to process the request due to an overload or
maintenance problem. Upon receiving this response, the
gateway initiates a graceful call disconnect and
clears the call. "
Look like a pstn config issue. Use "debug isdn q931",
"debug isdn q921" and "term mon" for further debuging.
Cheers,
Richard
--- CM Rahman <cmrahman at ccsi.com> wrote:
> Looking through your cisco config file, I am
> guessing your E1 are not
> Pri. Ami I correct? I am dealing with a channelized
> DS3 with T1 Pri. I
> will also share my config file after I can get the
> call routed.
> Currently I am getting this below. My understanding
> is there is
> something wrong in the call going from cisco to Pri
> trunk. Anybody can
> give me some clue, that will be great.
>
>
>
> 146.82.136.218:5060 -> 216.236.160.11:5060
> SIP/2.0 503 Service Unavailable..Via: SIP/2.0/UDP
> 216.236.160.11;branch=z9h
> G4bKc513.1c338976.0,SIP/2.0/UDP
> 65.70.207.66:8675..From:
> "pappusip at backup.c
> csi.com"
>
<sip:pappusip at backup.ccsi.com>;tag=c270cb2a9ab14343b72218adb808612
> 4;epid=c91b05026b..To:
> <sip:915125656553 at backup.ccsi.com>;tag=E8186070-487.
> .Date: Tue, 15 Feb 2000 01:38:28 GMT..Call-ID:
> 9fef06800312431fbaa33d389f7d
> 3ac7 at 192.168.1.101..Server:
> Cisco-SIPGateway/IOS-12.x..CSeq: 1
> INVITE..Allo
> w-Events: telephone-event..Content-Length: 0....
>
>
>
>
>
>
&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*
> C.M. Rahman Jr.
> CTO
> CCNP, MCSE Security "Secure your self by securing
> your System"
> CompTI Security Plus Certified
> CCS Internet
> http://www.ccsi.com
> 13704 Research Blvd. Building O-Suite 4
> Austin, TX 78750
> Tel: 512-257-2274 Ex: 115
>
>
> -----Original Message-----
> From: Stephen Kingham
> [mailto:Stephen.Kingham at aarnet.edu.au]
> Sent: Thursday, June 24, 2004 11:56 PM
> To: CM Rahman
> Cc: serusers at lists.iptel.org
> Subject: Re: [Serusers] as5400 and ser
>
> Hi
>
> Along with several other we are putting together a
> SER implementation
> Tutorial for the R&E sector.
>
> We have a page up the the AS5300 and it may help
> you, also if anyone is
> interested in reviewing it?
>
>
http://www.aarnet.edu.au/events/conferences/2004/apan-questnet/sipworksh
> op/uas/ciscoas5300.html
>
> Regards
>
> Stephen
>
> CM Rahman wrote:
>
> >Anybody here using cisco as5400 for PSTN
> termination? I am having some
> >problem with call routing. If there are such person
> will to help,
> please
> >drop me an email.
> >
> >Thanks
> >
>
>&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*&*
> >C.M. Rahman Jr.
> >CCNP, MCSE Security "Secure your self by
> securing your System"
> >CompTI Security Plus Certified
> >CCS Internet
> >http://www.ccsi.com
> >13704 Research Blvd. Building O-Suite 4
> >Austin, TX 78750
> >Tel: 512-257-2274 Ex: 115
> >
> >-----Original Message-----
> >From: serusers-bounces at lists.iptel.org
> [mailto:serusers-bounces at lists.iptel.org] On
> >Behalf Of Atle Samuelsen
> >Sent: Thursday, June 24, 2004 7:29 PM
> >To: Andreas Granig
> >Cc: serusers at lists.iptel.org
> >Subject: Re: [Serusers] Weird problem when,
> restarting ser.
> >
> >Hi Andy
> >
> >* Andreas Granig <a.granig at inode.at> [040625
> 02:19]:
> >
> >
> >>Andrei Pelinescu-Onciul wrote:
> >>
> >>
> >>>>>It started with log entries like this:
> >>>>>
> >>>>>Jun 24 11:55:54 voip
> /usr/local/ser/sbin/ser[16801]: ERROR:
> >>>>>build_req_buf_from_sip_req: out of memory
> >>>>>Jun 24 11:55:54 voip
> /usr/local/ser/sbin/ser[16801]: ERROR:
> >>>>>print_uac_request: no pkg_mem
> >>>>>Jun 24 11:55:54 voip
> /usr/local/ser/sbin/ser[16801]: ERROR:
> >>>>>t_forward_nonack: failure to add branches
> >>>>>
> >>>>>
> >>>This could be a mem. leak (but this is unrelated
> to the startup
> >>>problem).
> >>>
> >>>
> >>I use a stock SER (0.8.12) without modifications.
> I just execute some
> >>external C code by exec_dset and exec_msg, but
> this shouldn't matter.
> >>
> >>Since this problem occured on our public server, I
> just wanted to get
> >>the service up and running again and thus didn't
> think about dumping
> >>
> >>
> >the
> >
> >
> >>database for later analysis on the test system.
> However, I'll try to
> >>reproduce this effect and send some logs...
> >>
> >>
> >
> >I would check with Andrei and see what he says.
> >
> >-Atle
> >
> >_______________________________________________
> >Serusers mailing list
> >serusers at lists.iptel.org
> >http://lists.iptel.org/mailman/listinfo/serusers
> >
> >
> >_______________________________________________
> >Serusers mailing list
> >serusers at lists.iptel.org
> >http://lists.iptel.org/mailman/listinfo/serusers
> >
> >
>
> --
> Stephen Kingham, MIT, BSc, E&C Cert
> Project Manager and Consulting Engineer
> mailto:Stephen.Kingham at aarnet.edu.au
> Telephone +61 2 6222 3575 (office)
> +61 419 417 471 (mobile)
> Voice and Video over IP
> for The Australian Academic Research Network
> (AARNet) and
> http://www.aarnet.edu.au
>
>
> _______________________________________________
> Serusers mailing list
> serusers at lists.iptel.org
> http://lists.iptel.org/mailman/listinfo/serusers
>
__________________________________
Do you Yahoo!?
Yahoo! Mail is new and improved - Check it out!
http://promotions.yahoo.com/new_mail
_______________________________________________
Serusers mailing list
serusers at lists.iptel.org
http://lists.iptel.org/mailman/listinfo/serusers
More information about the sr-users
mailing list