[Serusers] SER + asterisk + SecurityServer
Daniel-Constantin Mierla
daniel at iptel.org
Tue Jul 13 14:11:58 CEST 2004
On 7/13/2004 11:54 AM, Daniel-Constantin Mierla wrote:
> Hello,
> I guess you start ser in non-forking mode (fork=no in config file) and
> therefore only one process is created which will listen on the first
> interface found -- that is usually loopback (127.0.0.1). If you want
> to set explicitly the IP address to listen to, use listen=ip_address
> in config file. You can have ser listening to all IP addresses setting
> fork=yes and number of children greater than number op IPs (in config
> file: children=N).
errata: the number of children is set per interface, no need to be
greater than number of IPs, just set fork=yes (thx to Andrei for attention).
>
> Daniel
>
> On 7/13/2004 11:42 AM, Cyprien Simons wrote:
>
>> Hi,
>>
>> I want SER to accept request only from 2 given IP. So I wrote my
>> configuration file like this:
>>
>> if (source IP is the first IP) then {...} else if (source IP is the
>> second IP) then {...}
>>
>> but when I'm launching SER he tells me "more than one listen address
>> found (will use only the the first one)".
>>
>> any ideas?
>>
>> Cyprien
>>
>> _______________________________________________
>> Serusers mailing list
>> serusers at lists.iptel.org
>> http://lists.iptel.org/mailman/listinfo/serusers
>>
>>
>>
>
> _______________________________________________
> Serusers mailing list
> serusers at lists.iptel.org
> http://lists.iptel.org/mailman/listinfo/serusers
>
More information about the sr-users
mailing list