[Serusers] Re: [Serdev] configure radius support and question on debug

[Yang Xiang]

Hi, juha,

Thank you for your reply. Radiator works now. The mistake was that I used
"ServerChecksPassword" instead of "EncryptedPasswordAtrr" for OpenLDAP and
the OpenLDAP could not find any password in the request sent by radiator, of
course.

Best regards

yang

----- Original Message -----
From: "Juha Heinanen" <jh at lohi.eng.song.fi>
To: "Xiang" <xia at iitb.fhg.de>
Cc: "Yang Xiang" <yang.xiang at iitb.fraunhofer.de>; "Jan Janak"
<jan at iptel.org>; "Andrei Pelinescu-Onciul"
<pelinescu-onciul at fokus.fraunhofer.de>; <serdev at lists.iptel.org>;
<serusers at lists.iptel.org>
Sent: Tuesday, May 13, 2003 6:34 AM
Subject: Re: [Serdev] configure radius support and question on debug


> Xiang writes:
>
>  > this is just for freeradius but not Radiator.
>
> sorry, i didn't read your message carefully enough.  in case of
> radiator, you don't need to do anything special in the configuration.
> just install the latest radiator and then make sure your config can
> handle the service-types you have configured ser to use.  for example,
> you can have
>
> <Handler Service-Type=SIP>
> ...
> </AuthBy>
>
> or whatever your strategy is.
>
> -- juha
>
>