[OpenSER-Users] Problem with OpenXCAP, Please Help

[Kirti Dhingra]

Hi,

 I am having problems using OpenXCAP and somehow need to make it work. I 
set it up on a RHEL 4 machine, and followed all the steps listed on the 
openxcap installation page.

Now when I run the openxcap process, It shows that the process has started 
and the twisted framework is listening on port 8000, but whenever I add a 
contact on Eyebeam where remote storage is enabled to XCAP, I get a 
message that Eyebeam could not add the contact due to failed 
authentication. I have enabled Use SIP credentials in the storage settings 
on XCAP.

My XCAP Root URi in the config file for OpenXCAP is 
http://10.203.144.172/xcap-root/ while in Eyebeam it is 
http://10.203.144.172:8000/xcap-root/.

There are no traces shown in syslog for OpenXCAP when it receives a 
message. Is there anyway to get detailed traces for openXCAP. Also it may 
be possible that Eyebeam supports only https,
but I do not wish to use https.

Any help would be greatly appreciated.


Thanks & Regards,
Kirti Dhingra


***********************  Aricent-Unclassified   ***********************
"DISCLAIMER: This message is proprietary to Aricent  and is intended solely for the use of 
the individual to whom it is addressed. It may contain privileged or confidential information and should not be 
circulated or used for any purpose other than for what it is intended. If you have received this message in error, 
please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly
prohibited from using, copying, altering, or disclosing the contents of this message. Aricent accepts no responsibility for 
loss or damage arising from the use of the information transmitted by this email including damage from virus."
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.kamailio.org/pipermail/users/attachments/20071026/fbfea251/attachment.htm