[Users] switch - pseudo vars

[Cseke Tamas]

Hello,

Thanks the information!

Perhaps are the following commands valid in 1.2.0?

route($avp(s:callee_routeid[0]))
t_on_failure($avp(s:callee_routeid[0]))

These would be the better solution for me.

And i need a method to pop the first element from the array of avps, 
like a fifo, is it possible ?

Thanks,
Tamas


Daniel-Constantin Mierla wrote:

> Hello,
>
> just to make it clear, the switch you try is valid with 1.2.0. For 
> 1.1.0, the option given by Klaus in another email is the way to go.

>
> Cheers,
> Daniel
>
> On 02/09/07 14:30, Cseke Tamas wrote:
>
>> Hello,
>>
>> I'm using openser 1.1.0
>>
>> I'd like to make a dinamic routing, the plan is radius set an avp, 
>> which contains the routeid,
>> but my config is bad, and i don't know what can be the problem
>>
>> route($avp(i:20)); don't work so i tryied this way:
>>
>> switch($avp(i:20)) {
>> case 0:
>> route(0);
>> break;
>> case 1:
>> route(1);
>> break;
>> case 2:
>> route(2);
>> break;
>> }
>>
>> but this is bad too, can anybody give me an advice?
>>
>> the problem is in the line "switch($avp(i:20)) {" i guess,
>> but switch can accept pseudo vars, so i don't kow what the problem 
>> caould be?
>>
>> Thanks any help,
>> Tamas
>>
>>
>> _______________________________________________
>> Users mailing list
>> Users at openser.org
>> http://openser.org/cgi-bin/mailman/listinfo/users
>>
>


-- 
Cseke Tamás, fejlesztő
www.eworldcom.hu
1027 Budapest, Csalogány u. 23-33
Tel.: +36 1 999-7400
Fax: +36 1 999-7401

Jelen üzenet és az összes hozzá csatolt állomány bizalmas. Kérjük 
kezelje bizalmasan, és ne adja tovább  harmadik fél részére és ne 
készítsen  róla  másolatot.  Amennyiben Ön  nem a levél címzettje 
kérjük  jelezze  az  eWorld Com   számára  és törölje a levelet a 
számítógépéről.