[OpenSER-Users] [Serusers] Run on multiple ports

[Greger Viken Teigre]

0.9.x has an issue where outgoing messages don't go out on the incoming 
interface, but rather the main. This also holds for source port used when 
listening on multiple ports. The trace will show this if this is the issue 
you see.

2.x automatically stores and uses correct interface and port. You can also 
force source interface and port.
g-) 

------- Original message -------
From: Arun Kumar <arunvoip at gmail.com>
Cc: serusers at lists.iptel.org, users at openser.org
Sent: 28.12.'07,  19:15

> 
> 
> 1. Are you updating the port to 5070 for UA B in your configuration. 
> 
> yes
> 
> 
> 
> 2. Are you sure that cisco is not blocking incoming traffic for 5070. 
Maybe its allowing only outgoing traffic. 
> 
> I've configured my cisco to block udp/tcp 5060 only rest traffic is 
allowed , that is why I'm able to reg. on port 5070 and call users who are 
on 5060 but not rev.
> 
> thanks
> 
> arun
> 
> 
> 
> -Jai
> 
> On Dec 28, 2007 9:52 AM, Arun Kumar <arunvoip at gmail.com> wrote:
> Hi,
> 
> 
> how do I run ser/openser on multiple ports. ?
> 
> I've configured my ser with two listen stat.
> listen = ip:5060
> listen = ip:5070
> 
> UA:5070 -------> Cisco (Blocked 5060) --------> SER -------------> UB:5060
> 
> 
> UA is able to call UB, but UB is not able to call UA, I know 5060 is 
blocked but it should goto 5070 ? please guide on this ?
> 
> 
> Thanks,
> 
> Arun
> 
> 
> 
> 
> _______________________________________________
> Serusers mailing list
> Serusers at lists.iptel.org
> http://lists.iptel.org/mailman/listinfo/serusers
> 
> 
>