[Users] Re: how to run openser through monit daemon?

[Bogdan-Andrei Iancu]

may openser fails to start due a configuration error - check the log for 
potential errors and hints.

regards,
bogdan

Padmaja RV wrote:

> Hi!
> Thank you for the mail.
>
> I have already followed all the steps mentioned in the links .
> http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_cvs 
>
> http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
>
> ... pls see my previous mail below.... after all these steps when i 
> actually want to run openser from  /etc/init.d/openser start command, 
> it starts monit daemon and then the command prompt appears back..... 
> when i go to the directory /var/run/ i cant see the openser.pid file 
> and also the monit daemon after a while responds that it could nt 
> start openser. this i can see at http://localhost:2812 where the web 
> interface for the monit is running...........
>
> Please let me know the problem free and preferred source of running 
> openser.... which is the best way to run openser (is it from binary or 
> cvs)?
>
> Thanks and Regards,
> Padmaja
> ----- Original Message ----- From: "Bogdan-Andrei Iancu" 
> <bogdan at voice-system.ro>
> To: "Padmaja RV" <padmaja.rv at vodcalabs.com>
> Cc: <users at openser.org>
> Sent: Tuesday, May 30, 2006 1:20 PM
> Subject: Re: [Users] how to run openser through monit daemon?
>
>
>> Hi,
>>
>> See 
>> http://openser.org/dokuwiki/doku.php?id=make_openser.init_script_work
>>
>> regards,
>> bogdan
>>
>> Padmaja RV wrote:
>>
>>> Hi all!
>>> I have installed openser through CVS from the following link
>>> http://openser.org/dokuwiki/doku.php?id=install_and_maintain_openser_from_cvs 
>>>
>>>
>>> till the 8 th step in the link everything went well fine. in the 9 
>>> th step, there is a link to make oepnser.init script work and i did 
>>> all the steps as described. I downloaded and installed the monit 
>>> daemon to start openser thru it. however, now if i type 
>>> /etc/init.d/openser start, it says command monit to start openser 
>>> and then the command prompt appears back. i dont see the tcp and udp 
>>> ports (5060 ) and other information etc when the openser is 
>>> started.....and i cant figure out if it is running at all.....if i 
>>> issue ps command, i dont see any pid for openser.....if i open the 
>>> web interface of the monit daemon, i see that it is trying to start 
>>> the openser but after some time it shows failed to start......
>>>
>>> please let me know what to do asap.....
>>> Thanks
>>>
>>
>>
>