[Users] more on accounting
tele
tele at plexia.com
Fri Jul 7 19:26:53 CEST 2006
Hi bogdan,
now it works i can see the debug messages and OpenSER correctly swap
From/To for the accounting.
But i didn't change the config, the only thing is that now signalling
message come from another proxy and not directly from UA.
thank you for the support.
On Mon, 2006-07-03 at 09:44 +0200, tele wrote:
> Hi Bogdan,
>
> I've updated to last CVS-head version. but in the log i can't see debug
> messages.
> maybe there is an error in my accounting configuration. pls have a look:
>
> modparam("acc", "log_level", 2)
> modparam("acc", "log_fmt", "cdfimorstup")
> modparam("acc", "report_ack", 0)
> modparam("acc", "detect_direction", 1)
> modparam("acc", "radius_flag", 3)
> modparam("acc", "radius_missed_flag", 5)
> modparam("acc", "radius_config",
> "/usr/local/etc/radiusclient-ng/radiusclient_auth.conf")
> modparam("acc", "radius_extra", "h323-setup-time=$avp(setup_time);
> h323-connect-time=$avp(connect_time);
> h323-disconnect-time=$avp(disconnect_time);
> h323-remote-address=$avp(remote_address)")
>
> and before loose_route() i have:
>
> if (is_method("BYE"))
> {
> setflag(3);
> setflag(5);
> };
>
> is it correct?
>
> Bogdan-Andrei Iancu wrote:
>
> > Hi,
> >
> > as I saw in the log, the FROM restoring in BYE works properly, so
> > RR/Route processing is fine. Are you sure you enabled the accounting
> > for BYE?
> >
> > just in case, I added some more debug messages about this on cvs -
> > please update and see the output. You should get:
> > DBUG:acc:acc_onreq: UPSTREAM req detected -> flaging it
> > and
> > DBUG:acc:fmt2strar: UPSTREAM flag set -> swap F/T
>
>
>
> _______________________________________________
> Users mailing list
> Users at openser.org
> http://openser.org/cgi-bin/mailman/listinfo/users
More information about the Users
mailing list