[Users] need to find out OUTGOING IF / SOCKET

[Bogdan-Andrei Iancu]

Hi Gerry,

there is a new pseudo variable - fs - forced socket - you can inspect it 
after the lookup("") to see what will be the outgoing interface. for the 
static routing, I think it's quite easy to figure out.

regarding the rtpproxy, have you tried to use the "i" and "e" flags?
    http://openser.org/docs/modules/1.1.x/nathelper.html#AEN275

regards,
bogdan

Gerry wrote:

>
> Dear openser-users,
>
> I am trying to set-up a configuration where openser + RTPproxy are 
> relaying messages between disconnected networks (i.e. openser + 
> RTPproxy having more than one network-interface). With this method, I 
> could additionally bridge IPv4-only and IPv6-only clients. Therefore I 
> need to find out, on which interface (or socket, respectively) openser 
> will send the message out because RTPproxy needs this info and is too 
> dumb to find out by itself.
> I currently have a _very_ complicated solution which utilizes AVPs and 
> mysql and it fails with NATed clients (detail: because the "contact" 
> changes, I cannot look it up in the DB again).
> So, if you have any solutions or hints I would be VERY happy to "hear" 
> from you.
>
> Greetings, Gerry.
>
> P.S.: Of course, I would be happy to share my config, but I don't want 
> to SPAM this list. Therefore, if you are interested, just ask! But 
> remember: my solution ONLY makes sense, if you're relaying between 
> disconnected networks!
>
>
> _______________________________________________
> Users mailing list
> Users at openser.org
> http://openser.org/cgi-bin/mailman/listinfo/users
>