[SR-Users] STUN

[Mojtaba]

The STUN solutions for NAT traversal is classified as near-end.This
solutions implemented on the client-side, Then you don't need to
configure kamailio.
Be notice only the TURN solution is used on server-side. The TURN
solution  needs some configurations in Kamailio.
With Regards.Mojtaba

On Mon, May 7, 2018 at 5:29 PM, Wilkins, Steve <swwilkins at mitre.org> wrote:
> So If I already have a Stun Server, I don’t need to configure Kamailio to
> use that Server…Is that correct?
>
>
>
> Thank you
>
>
>
> From: sr-users [mailto:sr-users-bounces at lists.kamailio.org] On Behalf Of
> Sergiu Pojoga
> Sent: Sunday, May 6, 2018 11:49 AM
> To: Kamailio (SER) - Users Mailing List <sr-users at lists.kamailio.org>
> Subject: Re: [SR-Users] STUN
>
>
>
> Simple, load the stun module then point the device' stun address to your
> kamailio host on port 5060 (or whatever SIP listening port is configured)
>
>
>
> On Sun, May 6, 2018 at 11:12 AM, Wilkins, Steve <swwilkins at mitre.org> wrote:
>
> Hello all,
>
>
>
> Does anyone know the current status of how to enable STUN.  I am using
> Kamailio Ver 5.x.
>
>
>
> Thank you,
>
> -Steve
>
>
> _______________________________________________
> Kamailio (SER) - Users Mailing List
> sr-users at lists.kamailio.org
> https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users
>
>
>
>
> _______________________________________________
> Kamailio (SER) - Users Mailing List
> sr-users at lists.kamailio.org
> https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users
>



-- 
--Mojtaba Esfandiari.S